TOSS WELDTRONICS

The MIG welding process is semi-automated. This is also called as Gas Metal Arc Welding (GMAW). The process of MIG welding was developed in 1940. As this is a semi-automated process so there is a constant supply of filler wire in the form of MIG wire. This wire is being supplied by wire feeder which has a motorized function. The wire passed through the liner which also has a gas feeding through the same cable to the point where an arc is formed. The MIG welding is used in fabrication where higher production is required. The process needs electricity to produce heat, electrode or filler wire for the joint and inert gas to protect the welding joint from the air in the form of an inert gas of Co2. We ask you to buy MIG welder and if a robot is used in this welding process this welding becomes automatic. This MIG welding process is fast, cost effective and produces more welding units in a small period of time so it is a more effective method of welding.

The types of wire used are Carbon steel, stainless steel, and Aluminium. The wire feeder needs special change for the Aluminium wire filler. The carbon steel is best suited for the MIG welding. The welding by MIG are as welding is clean without smoke, very cheap, fast, time-saving in changing of the electrode is minimum so time efficient. It is good for spot and tack welds

• Digital Panel for adjusting the welding parameters.
• 30% more Energy efficient than conventional machines.
• Maximum Power factor is 0.94.
• Excellent dynamic response enables superior arc characteristics.
• 2T, 4T operating modes.
• Electronic choke adjustment for better arc control.
• Crater voltage and Crater current adjustment through digital panel.
• Unique feature of Fresh Tip Transfer (FTT) to avoid globule formation.
• Automatic “Weld Stop” facility.

• Most reliable and dependable thyristor based power source for high quality MIG / MAG semi automatic manual and semiautomatic
• mechanized welding applications.
• Hex phase, full wave full control bridge rectification circuit reduces ripple in the welding output - resulting in spatter free welding.
• Special design and construction of Transformer - resulting faster response time and excellent Arc dynamics.
• Light weight, Compact design of power source, wire feeder and Torch.
• Adjustment of Crater Voltage, Crater Current possible with regulating pots provided on the front panel.
• Globule detach technique keeps the tip ready for next welding cycle.
• Choice of different types of wire feeder motors and welding torches available for different industrial applications.
• Quick release wire feed roller mechanism enables operator to change the wire spool quickly, minimizing the unproductive time
• and thus increasing the productivity on the shop floor.
• Power source protected from Over Voltage,Under Voltage supply, Single phasing, Over load / overheating and very high secondary short circuit current.
• Suitable for ALL position MIG / MAG welding applications -both within shop-floor as well as at open yards and project sites (with due protection or shield against windy air).
• Suitable for wide range of metals like Carbon Steel, Stainless Steel, Aluminium and its alloys,with appropriate or recommended consumable.
• Specifically designed for heavy duty, structural welding, machine building applications.